@article { author = {Amanat, Bentolhoda and Khalilazad, Mahdi}, title = {Analysis of vibration characteristics of piezocomposite based on PMN-PT}, journal = {Hydrophysics}, volume = {7}, number = {2}, pages = {145-152}, year = {2022}, publisher = {Malek Ashtar university of technology}, issn = {2476-7131}, eissn = {2476-7468}, doi = {}, abstract = {In this article, the characteristics of 1-3 piezocomposites based on PMN-PT relaxor single crystals with different percentages of PT were investigated. For this purpose, parameters of electromechanical coupling coefficient, longitudinal velocity and acoustic characteristic impedance were calculated and analyzed with the help of effective parameters model. It was observed that the change of PT percentage has a significant effect on the mentioned quantities. For example, by changing the percentage of PT, the electromechanical coupling coefficient can be increased to more than 90%. In addition, by using the appropriate amount of volume fraction of single crystals, it is possible to greatly reduce the longitudinal velocity, and therefore the characteristic acoustic impedance, as shown by using PMN-0.33PT single crystal in volume fraction. 0.4, a longitudinal velocity of 3300 m/s and an acoustic characteristic impedance of 1.3 MRayl can be achieved, while the coupling coefficient is close to 90%. According to the obtained results, it was seen that the changes in the functional parameters of 1-3 piezocomposite based on PMN-PT single crystals were not linear in relation to the percentage of PT, and necessarily with the decrease or increase in the percentage of PT, the values of electromechanical coupling coefficient, longitudinal velocity and the characteristic acoustic impedance does not decrease or increase, and the optimal point should be found by examining different percentages of PT according to the desired application.}, keywords = {Piezocomposite,electromechanical coupling coefficient,Piezoelectric,PMN-PT}, title_fa = {آنالیز مشخصات ارتعاشی پیزوکامپوزیت بر پایه PMN-PT}, abstract_fa = {در این مقاله ویژگی‌های پیزوکامپوزیت‌های 3-1 بر پایه تک کریستال های رلاکسور PMN-PT ، با درصدهای مختلف PT مورد بررسی قرار گرفت. برای این منظور پارامترهای ضریب جفت شدگی الکترومکانیکی، سرعت طولی و امپدانس مشخصه آکوستیکی به کمک مدل پارامترهای موثر محاسبه و مورد مطالعه قرار گرفت. مشاهده شد تغییر درصد PT، تاثیر قابل توجهی بر کمیت‌های یاد شده دارد. به عنوان مثال با تغییر درصد PT می توان ضریب جفت شدگی الکترومکانیکی را به بیش از 90 درصد افزایش داد. علاوه بر این با استفاده از مقدار مناسب کسر حجمی تک بلورها می توان سرعت طولی و امپدانس مشخصه آکوستیکی را به میزان زیادی کاهش داد، به گونه‌ای که نشان داده شد با استفاده از تک کریستال PMN-0.33PT در کسر حجمی 0.4 می توان به سرعت طولی m/s 3300 و امپدانس مشخصه آکوستیکی MRayl 1.3 دست پیدا کرد، در حالی که ضریب جفت شدگی نزدیک به 90 درصد می رسد. با توجه به نتایج بدست آمده دیده شد که تغییرات پارامترهای عملکردی پیزوکامپوزیت 3-1 بر پایه تک کریستال‌های PMN-PT نسبت به درصد PT به صورت خطی نبوده است و لزوما با کاهش و یا افزایش درصد PT مقادیر ضریب جفت شدگی الکترومکانیکی، سرعت طولی و امپدانس مشخصه آکوستیکی کاهش یا افزایش پیدا نمی کند و باید با بررسی درصدهای مختلف PT نقطه بهینه را با توجه به کاربرد مورد نظر به شکل مناسب پیدا کرد.}, keywords_fa = {پیزوکامپوزیت,ضریب جفت‌شدگی الکترومکانیکی,پیزوالکتریک,PMN-PT}, url = {https://www.hydrophysics.ir/article_699729.html}, eprint = {https://www.hydrophysics.ir/article_699729_bda2632f421fedbdf8dc355a47f967ab.pdf} }